contact the publishing agency. (In the example, the special provision codes for toluene are IB2, T4 and TP1.) (3) When no bottom openings are authorized, the alternative portable tank must not have bottom openings. (c) Tables of special provisions. This entry applies to machinery or apparatus containing hazardous materials as a residue or as an integral element of the machinery or apparatus. 128 Regardless of the provisions of 172.101(c)(12), aluminum smelting by-products and aluminum remelting by-products described under this entry, meeting the definition of Class 8, Packing Group II and III may be classed as a Division 4.3 material and transported under this entry. 168 For lighters containing a Division 2.1 gas (see 171.8 of this subchapter), representative samples of each new lighter design must be examined and successfully tested as specified in 173.308(b)(3). B33 MC 300, MC 301, MC 302, MC 303, MC 305, MC 306, and DOT 406 cargo tanks equipped with a 1 psig normal vent used to transport gasoline must conform to Table I of this Special Provision. site when drafting amendatory language for Federal regulations: In addition to the packaging required in 173.4a, each glass inner packaging must be placed in a sealed plastic bag compatible with ethylene oxide and capable of containing the contents in the event of breakage or leakage of the glass inner packaging; and. For transportation by aircraft, the provisions of 173.159(b)(2) apply. (contains magnesium, magnesium nitrides) in PG II or III may be packaged in sift-proof bulk packagings that prevent liquid from reaching the hazardous material with sufficient venting to preclude dangerous accumulation of flammable, corrosive or toxic gaseous emissions such as methane, hydrogen and ammonia. It must not be used for machinery or apparatus for which a proper shipping name already exists in the 172.101 Table. The caps must not contain more than an average of twenty-five hundredths of a grain of explosive composition per cap; c. The caps must be packed inside packagings constructed of cardboard not less than 0.013-inch in thickness, metal not less than 0.008-inch in thickness, non-combustible plastic not less than 0.015-inch in thickness, or a composite blister package consisting of cardboard not less than 0.013-inch in thickness and non-combustible plastic not less than 0.005-inch in thickness that completely encloses the caps; d. The minimum dimensions of each side and each end of the cardboard packaging must be 1/8th inch in height or more; e. The number of caps inside each packaging must be limited so that not more than 10 grains of explosives composition may be packed into one cubic inch of space, and not more than 17.5 grains of the explosive composition of toy caps may be packed in any inner packaging; f. Inner packagings must be packed in outer packagings meeting PG II performance criteria; g. Toy caps may be packed with non-explosive or non-flammable articles provided the outer packagings are marked as prescribed in this paragraph; h. Toy paper caps of any kind must not be packed in the same packaging with fireworks; i. The material may only be loaded with Class 3, Class 8, and Division 4.1 materials in Packing Group II or III. IBCs of type 31A and 31N are only authorized if approved by the Associate Administrator. 238 Neutron radiation detectors: Neutron radiation detectors containing non-pressurized boron trifluoride gas in excess of 1 gram (0.035 ounces) and radiation detection systems containing such neutron radiation detectors as components may be transported by highway, rail, vessel, or cargo aircraft in accordance with the following: a. Hazardous Materials Tables | High Road Online CDL Training - TruckingTruth Hazardous materials shipped under this entry are excepted from the labeling requirements of this subchapter unless offered for transportation or transported by aircraft and are not subject to the placarding requirements of subpart F of this part. A200 These articles must be transported as cargo and may not be carried aboard an aircraft by passengers or crewmembers in carry-on baggage, checked baggage, or on their person unless specifically authorized in 175.10. Transport vehicles must be vented to prevent accumulation of vapors at a poisonous or flammable concentration. Specification 110A500W tanks must be stainless steel. Determining Authorized Packaging for the Transportation of a Hazardous (1) Numeric provisions. 169 This entry applies to lighter refills (see 171.8 of this subchapter) that contain a Division 2.1 (flammable) gas but do not contain an ignition device. Column 8 B115 Rail cars, highway trailers, roll-on/roll-off bins, or other non-specification bulk packagings are authorized. 11 The hazardous material must be packaged as either a liquid or a solid, as appropriate, depending on its physical form at 55 C (131 F) at atmospheric pressure. 389 This entry only applies to lithium ion batteries or lithium metal batteries installed in a cargo transport unit and designed only to provide power external to the cargo transport unit. 163 Substances must satisfactorily pass Test Series 8 of the UN Manual of Tests and Criteria, Part I, Section 18 (IBR, see 171.7 of this subchapter). 47 Mixtures of solids that are not subject to this subchapter and flammable liquids may be transported under this entry without first applying the classification criteria of Division 4.1, provided there is no free liquid visible at the time the material is loaded or at the time the packaging or transport unit is closed. Portable tank instructions T1 through T22 specify the applicable minimum test pressure, the minimum shell thickness (in reference steel), bottom opening requirements and pressure relief requirements. TP47 The 2.5 year internal examination may be waived or substituted by other test methods or inspection procedures specified by the competent authority or its authorized body, provided that the portable tank is dedicated to the transport of the organometallic substances to which this tank special provision is assigned. These provisions can be classified even further with each form of transportation. N5 Glass materials of construction are not authorized for any part of a packaging which is normally in contact with the hazardous material. e. A description to which special provision 170 or TP7 is assigned in Column 7 of the 172.101 Hazardous Materials Table, and therefore requires air to be eliminated from the package vapor space by nitrogen or other means, must not be offered for transportation under this description. The adsorbent or absorbent material shall not meet the definition or criteria for inclusion in Classes 1 to 8; c. The maximum contents of a receptacle shall be 10 kg of ammonia; and. The letter Z shown in the marking code for composite IBCs must be replaced with a capital code letter designation found in 178.702(a)(2) of this subchapter to specify the material used for the other packaging. This molecular arrangement is exactly the same as that for dithioketo QA [5]. B54 Open-top, sift-proof rail cars are also authorized. Column 3 specifies the section reference for minimum shell thickness or, alternatively, the minimum shell thickness value. When used for purposes such as sterilization, inner packagings of peroxyacetic acid, stabilized, classified as UN 3107 Organic peroxide type E, liquid or UN 3109 Organic peroxide type F, liquid may be fitted with a vent consisting of hydrophobic membrane, provided: (1) Each inner packaging contains not more than 70 mL; (2) The inner packaging is designed so that the vent is not immersed in liquid in any orientation; (3) Each inner packaging is enclosed in an intermediate rigid plastic packaging with a small opening to permit release of gas and contains a buffer that neutralizes the contents of the inner packaging in the event of leakage; (4) Intermediate packagings are packed in a fiberboard box (4G) outer packaging; (5) Each outer packaging contains not more than 1.4 L of liquid; and. When a placard is displayed, the placard must be the placard shown in 172.560. 148 For domestic transportation, this entry directs to 173.66 for: a. Lighter refills offered for transportation under this entry may not exceed 4 fluid ounces capacity (7.22 cubic inches) or contain more than 65 grams of fuel. B7 Safety relief devices are not authorized on multi-unit tank car tanks. For the regulatory description of the codes for special provisions, please refer to 49 CFR 172.102. b. 172.101 Hazardous Materials Table (HMT). When phlegmatized with water and inorganic inert material, the content of urea nitrate must not exceed 75 percent by mass and the mixture should not be capable of being detonated by test 1(a)(i) or test 1(a)(ii) in the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter). (3) A code containing the letter B refers to a special provision that applies only to bulk packaging requirements. Bulk outer packagings must be liquid tight through design or by the use of lining materials. ); and. (h) Column 7: Special provisions. If not impact resistant, the outer packaging should not be used as the sole means of protecting the battery terminals from damage or short circuiting. B16 The lading must be completely covered with nitrogen, inert gas or other inert materials. quantity (RQ)", contains the reportable quantity (RQ), in pounds and kilograms, for each hazardous substance listed in Column 1 of TABLE 1. (TOY CAPS) - HANDLE CAREFULLY OR TOY CAPS - HANDLE CAREFULLY; and. With less than 10 percent formaldehyde, are not subject to this subchapter. N74 Packages consisting of tightly closed inner containers of glass, earthenware, metal or polyethylene, capacity not over 0.5 kg (1.1 pounds) securely cushioned and packed in outer wooden barrels or wooden or fiberboard boxes, not over 15 kg (33 pounds) net weight, are authorized and need not conform to the requirements of part 178 of this subchapter. 166 When transported in non-friable tablet form, calcium hypochlorite, dry, may be transported as a Packing Group III material. A53 Refrigerating machines and refrigerating machine components are not subject to the requirements of this subchapter when containing less than 12 kg (26.4 pounds) of a non-flammable gas or when containing 12 L (3 gallons) or less of ammonia solution (UN2672) (see 173.307 of this subchapter). Interpretation Response | PHMSA - Pipeline and Hazardous Materials A chemical under pressure packaged in an aerosol dispenser must be transported under UN1950. Pressing enter in the search box d. The proper shipping name Printing ink related material may be used for consignments of packages containing Printing ink and Printing ink related material in the same package. 360 Vehicles powered only by lithium batteries must be described using UN3171, Battery-powered vehicle. Lithium batteries installed in a cargo transport unit, designed only to provide power external to the transport unit, must be described using UN3536, Lithium batteries installed in a cargo transport unit., 361 Capacitors with an energy storage capacity of 0.3 Wh or less are not subject to the requirements of this subchapter. 237 Batteries, dry, containing potassium hydroxide solid, electric storage must be prepared and packaged in accordance with the requirements of 173.159(a) and (c). (5) A code containing the letter N refers to a special provision which applies only to non-bulk packaging requirements. 177 Gasoline, or, ethanol and gasoline mixtures, for use in internal combustion engines (e.g., in automobiles, stationary engines and other engines) must be assigned to Packing Group II regardless of variations in volatility. Placards may be displayed for a hazardous material, even when not required, if the placarding otherwise conforms to the requirements of Subpart F of Part 172 [172.502(c)]. Tank car tanks must have a test pressure rating of 1,379 kPa (200 psig). b. 382 Packages containing toy plastic or paper caps for toy pistols described as UN0349, Articles, explosive, n.o.s. N25 Steel single packagings are not authorized. 110 Fire extinguishers transported under UN1044 and oxygen cylinders transported for emergency use under UN1072 may include installed actuating cartridges (cartridges, power device of Division 1.4C or 1.4S), without changing the classification of Division 2.2, provided the aggregate quantity of deflagrating (propellant) explosives does not exceed 3.2 grams per cylinder. These entries include hybrid electric vehicles powered by both an internal combustion engine and batteries. All successfully conducted tests or reassignment to another compatibility group require the issuance of a new or revised approval by the Associate Administrator prior to transportation on or after the dates specified for each authorized mode of transport in this special provision. The manufacturer must produce technical documentation of the design type, manufacture as well as the tests and their results. Others such as copper and silver are available in trace amounts. B77 Other packaging are authorized when approved by the Associate Administrator. In addition, the material also must be covered with an inert gas or the container must be filled with water to the tank's capacity. B67 All valves and fittings must be protected by a securely attached cover made of metal not subject to deterioration by the lading, and all valve openings, except safety valve, must be fitted with screw plugs or caps to prevent leakage in the event of valve failure. Transportation by vessel in IBCs is prohibited. See also UN1942 in the 172.101 Hazardous Materials Table. Comments or questions about document content can not be answered by OFR staff. Navigate by entering citations or phrases Example: Yes, I would like to receive emails from Daniels Training Services. e. When offered for transport in an ammonia dispenser, the receptacles shall be connected to the dispenser in such a way that the assembly is guaranteed to have the same strength as a single receptacle. A3 For combination packagings, if glass inner packagings (including ampoules) are used, they must be packed with absorbent material in tightly closed rigid and leakproof receptacles before packing in outer packagings. 387 When materials are stabilized by temperature control, the provisions of 173.21(f) of this subchapter apply. If it is evident that a package of radioactive material, or conveyance carrying unpackaged radioactive material, is leaking, or if it is suspected that the package, or conveyance carrying unpackaged material, may have leaked, the requirements of 173.443(e) of this subchapter apply.
Luxury Homes For Sale In Georgetown Washington, Dc,
How Does Kahoot Scoring Work,
Articles C
column 7 of the hazardous materials table